• Logo
  • SBMUJournals

Bond Strength of White Mineral Trioxide Aggregate with and without Disodium Hydrogen Phosphate with Different Liquid-to-Powder Ratios

Hadi Mokhtari, Sara Jafarizadeh, Hamid Reza Mokhtari Zonouzi, Mehrdad Lotfi, Mohammad Forough Reyhani, Aydin Sohrabi
275

Views

PDF

Abstract

Introduction: Mineral trioxide aggregate (MTA) can be used in the treatment of irritated vital pulp and repair of root perforations. However, the initial reaction of inflammatory cells to this material and also its setting time are not ideal. Studies have shown that disodium hydrogen phosphate (DHP), decreases the setting time of MTA, with no effect on its pH. This study was undertaken to evaluate the effect of DHP on push-out bond strength of MTA at different liquid-to-powder ratios. Methods and Materials: A total of 120 samples were prepared from the middle third of the roots of single-rooted teeth for evaluation of push-out bond strength. The push-out bond strength was measured in both groups after 72 h at different liquid-to-powder ratios, including 0.33:1, 0.5:1 and 0.6:1. Factorial ANOVA and Tukey’s HSD post-hoc tests were used to compare the differences between the independent groups. Statistical significant was set at P<0.05. Results: The push-out bond strengths of pure MTA and MTA+DHP groups were 10.96±5.78 and 13.32±5.03, respectively. Tukey’s HSD post-hoc test revealed significant differences between the two groups. Furthermore, there were no interactive effect between material and the liquid: powder ratio. Conclusion: Incorporation of DHP into MTA resulted in an increase in push-out bond strength of MTA, and an increase in liquid-to-powder ratio resulted in a decrease in push-out bond strength.

Keywords: Disodium Hydrogen Phosphate; Mineral Trioxide Aggregate; Push-Out Test; Root Canal Filling Materials; Root Canal Therapy

 




DOI: https://doi.org/10.22037/iej.v12i3.15600

Refbacks

  • There are currently no refbacks.